Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the range of 2.7V to 3.6V.
   • The device operates with low standby current (1-5 μA) and moderate active current (15-30 mA).

2. Programming:

   • During programming, the device requires a higher current (20-25 mA).
   • Erase operations can take between 1 to 5 seconds, depending on the operation (sector or chip erase).
   • Write operations (byte or page write) typically take 10 to 40 microseconds.

3. Timing Parameters:

   • Read Cycle Time (tRC): Minimum of 55 ns, typical of 70 ns.
   • Address Setup Time (tAS): Minimum of 20 ns.
   • Address Hold Time (tAH): Maximum of 10 ns.
   • Data Setup Time (tDS): Minimum of 20 ns.
   • Data Hold Time (tDH): Maximum of 10 ns.
   • Output Enable Setup Time (tOE): Minimum of 20 ns.
   • Output Enable Hold Time (tOH): Maximum of 10 ns.
   • Write Enable Setup Time (tWE): Minimum of 20 ns.
   • Write Enable Hold Time (tWH): Maximum of 10 ns.
   • Write Disable Time (tWP): Maximum of 10 ns.
   • Chip Enable Setup Time (tCS): Minimum of 20 ns.
   • Chip Enable Hold Time (tCH): Maximum of 10 ns.

4. Operating Conditions:

   • All timing parameters are specified at a supply voltage of 3V and ambient temperature of 25°C.
   • Ensure that all signals meet the setup and hold time requirements to avoid data corruption or incorrect operation.

5. Handling:

   • Handle the device with care to avoid static damage.
   • Follow proper ESD (Electrostatic Discharge) precautions during handling and installation.

6. Storage:

   • Store the device in a dry, cool place to prevent moisture damage.
   • Follow recommended storage conditions as specified in the datasheet.

For more detailed information, refer to the full datasheet provided by the manufacturer.