Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the specified range of 4.5V to 18V.
   • Use a stable power supply to avoid voltage fluctuations that can affect performance.

2. Input Signal:

   • Apply the input signal to the IN pin. The input voltage should be compatible with the Vcc level.
   • Ensure the input signal has clean edges to minimize propagation delay and ensure reliable operation.

3. Output Configuration:

   • Connect the load to the OUT pin. The maximum peak output current is 1.2A.
   • Place a suitable capacitor close to the output to stabilize the output voltage and reduce noise.

4. Thermal Management:

   • Ensure adequate heat dissipation by using a heatsink if necessary, especially for high-power applications.
   • Monitor the temperature to ensure it stays within the operating range of -40°C to 125°C.

5. Protection Features:

   • The device includes under-voltage lockout (UVLO) and thermal shutdown to protect against low supply voltage and overheating.
   • In case of a short circuit, the device will automatically shut down to prevent damage.

6. Storage:

   • Store the device in a dry environment within the temperature range of -65°C to 150°C.
   • Handle the device with care to avoid mechanical stress and electrostatic discharge (ESD).

7. Schematic and Layout:

   • Follow recommended PCB layout guidelines to ensure optimal performance and reliability.
   • Keep signal traces as short as possible to minimize parasitic inductance and capacitance.

8. Testing:

   • Test the device under typical operating conditions to verify its functionality.
   • Use appropriate test equipment to measure key parameters such as propagation delay, quiescent current, and output current.

By following these instructions, you can ensure the reliable and efficient operation of the FAN7602CMX and FAN7602C devices in your application.