Instructions for Use:

1. Input Capacitor Selection:

   • Use a ceramic capacitor with low ESR and X7R dielectric.
   • Recommended value: 10μF to 100μF.

2. Output Capacitor Selection:

   • Use a ceramic capacitor with low ESR and X7R or X5R dielectric.
   • Recommended value: 10μF to 22μF for stable operation.

3. Inductor Selection:

   • Choose an inductor with a saturation current greater than the maximum output current.
   • Recommended inductance: 1.5μH to 4.7μH.

4. Feedback Resistor Network:

   • Set the output voltage using the feedback resistor network.
   • Use the formula: ( V_ = 0.985 times left(1 + fracright) ).

5. Thermal Management:

   • Ensure proper heat dissipation by mounting the device on a PCB with a large copper area.
   • Use the exposed pad for thermal grounding.

6. Layout Considerations:

   • Keep the input and output capacitors close to the IC.
   • Minimize loop area for high-frequency currents to reduce EMI.

7. Enable Pin:

   • The enable pin can be used to control the on/off state of the regulator.
   • Apply a logic high (VIN) to turn on the regulator and a logic low (GND) to turn it off.

8. Soft-Start:

   • The soft-start feature reduces inrush current during startup.
   • The typical soft-start time is 1ms.

9. Overcurrent Protection:

   • The device has built-in overcurrent protection that limits the output current to prevent damage.
   • The protection threshold is typically set to 4.2A.

10. Thermal Shutdown:

    • The device will shut down if the junction temperature exceeds 160°C.
    • It will restart once the temperature drops below 145°C due to the hysteresis.

11. Storage and Handling:

    • Store the device in a dry, cool environment.
    • Follow standard ESD handling procedures to avoid damage.

For more detailed information, refer to the datasheet provided by Analog Devices.