Instructions for Use:

1. Handling and Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Handle with care to avoid mechanical damage.

2. Soldering:

   • Preheat components to 125°C ± 25°C for 5 minutes.
   • Soldering temperature should not exceed 260°C for more than 10 seconds.
   • Allow the capacitors to cool naturally after soldering.

3. Mounting:

   • Ensure the mounting surface is clean and free from contaminants.
   • Apply a small amount of flux to the pads before soldering.
   • Place the capacitor on the PCB with the correct orientation if marked.

4. Testing:

   • After assembly, perform visual inspection to ensure proper placement and soldering.
   • Use a capacitance meter to verify the capacitance value.
   • Test the circuit under normal operating conditions to ensure functionality.

5. Environmental Considerations:

   • Dispose of any defective or unused components according to local regulations.
   • Follow RoHS guidelines for environmental compliance.

6. Troubleshooting:

   • If the capacitor fails, check for overheating, incorrect voltage application, or physical damage.
   • Replace with a new capacitor of the same specifications if necessary.