Instructions for Using UCC28C45DGKR:

1. Power Supply Connection:

   • Connect the input voltage (VIN) between the VCC and GND pins.
   • Ensure the input voltage is within the specified range (10V to 60V).

2. Start-Up and Quiescent Current:

   • The device will start up when the VCC pin reaches the start-up threshold.
   • The quiescent current should be monitored to ensure efficient operation.

3. Output Voltage Regulation:

   • The output voltage (VOUT) is regulated to 14.5V under typical operating conditions.
   • Use appropriate feedback components to maintain regulation.

4. PWM Control:

   • The maximum duty cycle (DMAX) is set to 0.9 to prevent overdriving the switch.
   • Adjust the PWM signal to control the output power as needed.

5. Minimum Off Time:

   • Ensure the minimum off time (TOFF_MIN) is at least 1.7 μs to avoid shoot-through conditions.

6. Switching Frequency:

   • The typical switching frequency (fSW) is 100 kHz.
   • Adjust external components if a different frequency is required.

7. Thermal Management:

   • Monitor the temperature to ensure it does not exceed 160°C, which triggers thermal shutdown.
   • Use appropriate heatsinking or cooling methods if necessary.

8. Storage and Handling:

   • Store the device in a temperature range of -40°C to 150°C.
   • Follow standard ESD precautions during handling.

For detailed application circuits and further information, refer to the datasheet provided by Texas Instruments.