Instructions for Use:

1. Forward Current (IF):

   • Ensure the forward current does not exceed 50 mA continuously.
   • For peak applications, do not exceed 100 mA for more than 1 ms repetitively.

2. Output Collector-Emitter Voltage (VCEO):

   • The maximum output collector-emitter voltage is 30 V. Ensure that the load does not cause this voltage to be exceeded.

3. Output Collector Current (IC):

   • The typical output collector current is 50 mA, with a maximum of 100 mA under specified conditions.

4. Turn-On and Turn-Off Times:

   • The typical turn-on and turn-off times are 2 μs, with a maximum of 5 μs. These values are based on specific test conditions (IF = 5 mA, RL = 100 Ω, VCC = 5 V).

5. Isolation Voltage:

   • The device can withstand an isolation voltage of up to 2500 Vrms for 1 minute without damage.

6. Temperature Considerations:

   • The operating temperature range is from -40°C to 85°C.
   • The storage temperature range is from -55°C to 125°C.

7. Mounting and Handling:

   • Handle the device with care to avoid mechanical stress.
   • Follow proper soldering procedures to ensure reliable connections.

8. Electrostatic Discharge (ESD) Protection:

   • Use appropriate ESD protection measures during handling and assembly to prevent damage to the device.

9. Circuit Design:

   • Ensure that the circuit design includes necessary protection components such as current-limiting resistors and flyback diodes if required.

10. Compliance:

    • Verify that the application complies with relevant safety and regulatory standards.