Instructions for Use:

1. Power Supply:

   • Ensure that the supply voltage (V_DD) is within the range of 1.65V to 3.6V.
   • Connect the V_DD pin to the power supply and GND to ground.

2. Signal Connections:

   • Connect the input signals to the appropriate channels (IN1, IN2, IN3).
   • Connect the output signals to the common output (OUT).

3. Control Signals:

   • Use the control inputs (S0, S1, S2) to select the desired channel. The control signals should be logic levels compatible with the supply voltage.
   • The truth table for the control inputs is as follows:
     • S2 S1 S0 | Channel
     • 0 0 0 | OFF
     • 0 0 1 | IN1
     • 0 1 0 | IN2
     • 0 1 1 | IN3

4. Quiescent Current:

   • The quiescent current (I_Q) is typically 0.8 μA when all switches are off. This should be considered in low-power applications.

5. On-State Resistance:

   • The on-state resistance (R_ON) is between 4 Ω and 7 Ω at V_DD = 2.5V. This affects the signal integrity and power consumption when the switch is on.

6. Off-State Leakage Current:

   • The off-state leakage current (I_OFF) is typically 1 nA. This is important for applications where minimal leakage is required.

7. Switching Times:

   • The switching times (t_ON and t_OFF) are both typically 0.5 μs. This is useful for high-speed switching applications.

8. Temperature Considerations:

   • The operating temperature range is from -40°C to 85°C.
   • The storage temperature range is from -65°C to 150°C.

9. Handling and Storage:

   • Store the device in a dry environment to prevent moisture damage.
   • Handle the device with care to avoid static discharge, which can damage the internal components.

10. Testing:

    • Before integrating the device into a circuit, test it with a simple setup to ensure proper functionality.
    • Use a multimeter to check the continuity and resistance values when the switch is on and off.