Share:
Specifications
SKU: 11661470
| Parameter | Description | Min | Typ | Max | Unit |
|---|---|---|---|---|---|
| Supply Voltage (VCC) | Operating supply voltage range | 2.7 | - | 5.25 | V |
| Quiescent Current (IQ) | Supply current at no load | - | 450 | - | nA |
| Input Bias Current (IIB) | Current flowing into or out of the input terminals | - | 5 | - | pA |
| Input Offset Voltage (VOS) | Difference between the inverting and non-inverting input voltages | - | 5 | - | μV |
| Input Voltage Range | Range over which the input voltage can vary without causing clipping | VCC - 0.1 | - | VCC + 0.1 | V |
| Output Voltage Swing | Range over which the output voltage can swing | 0.01 | - | VCC - 0.01 | V |
| Slew Rate | Rate of change of output voltage with respect to time | - | 0.3 | - | V/μs |
| Gain Bandwidth Product (GBW) | Frequency at which the open-loop gain is unity | - | 4 | - | MHz |
| Common Mode Rejection Ratio (CMRR) | Measure of the ability to reject common-mode signals | 90 | - | - | dB |
| Power Supply Rejection Ratio (PSRR) | Measure of the ability to reject variations in the power supply | 90 | - | - | dB |
| Operating Temperature Range | Range of temperatures over which the device is specified to operate | -40 | - | 125 | °C |
Instructions for Use:
Supply Voltage:
- Ensure the supply voltage (VCC) is within the specified range of 2.7V to 5.25V.
- Connect the supply voltage to the VCC pin and ground to the GND pin.
Input Connections:
- Connect the signal to be amplified to the non-inverting (+) and inverting (-) input pins.
- Ensure the input voltage remains within the input voltage range (VCC - 0.1V to VCC + 0.1V).
Output Connections:
- The output voltage will swing from 0.01V to VCC - 0.01V.
- Connect the output to the desired load or next stage of the circuit.
Biasing and Feedback:
- Use appropriate biasing and feedback networks to set the desired gain and operating point.
- For non-inverting configurations, use a feedback resistor (RF) and a gain-setting resistor (RG).
Temperature Considerations:
- The device is specified to operate over a temperature range of -40°C to 125°C.
- Ensure the ambient temperature and any heat dissipation considerations are within these limits.
Power Supply Decoupling:
- Place a decoupling capacitor (typically 0.1μF) close to the VCC and GND pins to filter out high-frequency noise and stabilize the supply voltage.
Handling Precautions:
- Handle the device with care to avoid damage from electrostatic discharge (ESD).
- Follow proper soldering techniques to ensure reliable connections and prevent thermal stress on the device.
Inquiry - LMC7101BIM5X/NOPB
