Instructions for TPS65161PWP

1. Power Supply Connection:

   • Connect the input voltage (VIN) to the power supply.
   • Ensure the input voltage is within the operating range (2.7V to 5.5V).

2. Output Configuration:

   • Set the output voltages (VOUT1 and VOUT2) using external resistors or fixed voltage options.
   • Verify that the output voltages are within the range (0.8V to 3.3V).

3. Load Connection:

   • Connect the load to the output pins (VOUT1 and VOUT2).
   • Ensure the load current does not exceed the maximum output current (1.5A).

4. Thermal Management:

   • Place the device on a PCB with adequate thermal management to ensure it operates within the temperature range (-40°C to 85°C).
   • Use a heatsink if necessary to dissipate heat.

5. Shutdown Mode:

   • To enter shutdown mode, pull the SHDN pin low.
   • The shutdown current is typically 0.1 μA.

6. Capacitor Selection:

   • Use recommended input and output capacitors to stabilize the regulators.
   • Refer to the datasheet for specific capacitor values and types.

7. PCB Layout:

   • Follow the recommended PCB layout guidelines to minimize noise and improve performance.
   • Keep traces short and wide for power and ground connections.

8. Storage:

   • Store the device in a dry environment within the storage temperature range (-65°C to 150°C).

9. Handling:

   • Handle the device with care to avoid damage from electrostatic discharge (ESD).
   • Use proper ESD protection equipment when handling the device.

10. Testing:

    • Test the device under typical operating conditions to ensure it meets the specified performance parameters.
    • Monitor the output voltages and currents to verify proper operation.