Instructions for Using TJA1021T/10

1. Power Supply:

   • Connect the VCC pin to a power supply within the range of 3.0V to 5.5V.
   • Ensure the power supply is stable and has sufficient current capacity.

2. Ground Connection:

   • Connect the GND pin to a common ground reference.

3. CAN Bus Connections:

   • Connect the CANH and CANL pins to the CAN bus lines.
   • Ensure the CAN bus lines are terminated with a 120Ω resistor at both ends of the bus.

4. Sleep Mode:

   • To enter sleep mode, set the STBY pin to a high state (VCC).
   • To exit sleep mode, set the STBY pin to a low state (GND).

5. Data Transmission:

   • The TJA1021T/10 supports data rates up to 2 Mbit/s.
   • Ensure the data signals on the TXD and RXD pins are within the specified voltage levels.

6. Overvoltage Protection:

   • The device is protected against overvoltages up to 40V.
   • However, avoid exposing the device to voltages above this limit to prevent damage.

7. ESD Protection:

   • The device has an ESD rating of 4000V (Human Body Model).
   • Handle the device with care to avoid static discharge.

8. Temperature Considerations:

   • The operating temperature range is from -40°C to 125°C.
   • Store the device in an environment with temperatures between -65°C and 150°C.

9. Mounting and Handling:

   • Follow standard surface mount technology (SMT) procedures for mounting the device.
   • Use appropriate soldering techniques to ensure reliable connections.

10. Testing and Validation:

    • After assembly, perform functional tests to ensure the device is operating correctly.
    • Verify the CAN bus communication by sending and receiving data packets.

For detailed application notes and further information, refer to the datasheet provided by the manufacturer.