Share:
Specifications
SKU: 11750170
| Parameter | Description | Min | Typ | Max | Unit |
|---|---|---|---|---|---|
| Supply Voltage (VCC) | Operating supply voltage | 4.5 | - | 5.5 | V |
| Operating Temperature (TA) | Ambient operating temperature range | -40 | - | 85 | °C |
| Storage Temperature (TSTG) | Storage temperature range | -65 | - | 150 | °C |
| Input Voltage (VIH) | High-level input voltage | 2.0 | - | 5.5 | V |
| Input Voltage (VIL) | Low-level input voltage | 0.0 | - | 0.8 | V |
| Output Voltage (VOH) | High-level output voltage | 2.4 | - | 5.0 | V |
| Output Voltage (VOL) | Low-level output voltage | 0.0 | - | 0.4 | V |
| Propagation Delay Time (tpd) | Typical propagation delay time | - | 4.5 | - | ns |
| Power Dissipation (PD) | Maximum power dissipation | - | - | 350 | mW |
| Input Current (IIH) | High-level input current | - | 1 | - | μA |
| Input Current (IIL) | Low-level input current | - | -1 | - | μA |
| Output Current (IOH) | High-level output current | - | -4 | - | mA |
| Output Current (IOL) | Low-level output current | - | 16 | - | mA |
Instructions for Use:
Supply Voltage (VCC):
- Ensure the supply voltage is within the specified range of 4.5V to 5.5V to avoid damage to the device.
Operating Temperature (TA):
- The device is designed to operate within an ambient temperature range of -40°C to 85°C. Ensure the environment does not exceed these limits.
Storage Temperature (TSTG):
- Store the device in an environment with temperatures between -65°C and 150°C to prevent degradation.
Input Voltages (VIH, VIL):
- Apply high-level input voltages between 2.0V and 5.5V and low-level input voltages between 0.0V and 0.8V to ensure proper logic levels.
Output Voltages (VOH, VOL):
- The device will provide high-level output voltages between 2.4V and 5.0V and low-level output voltages between 0.0V and 0.4V.
Propagation Delay Time (tpd):
- The typical propagation delay time is 4.5 nanoseconds. This is the time it takes for a change in input to affect the output.
Power Dissipation (PD):
- The maximum power dissipation is 350 milliwatts. Ensure adequate heat dissipation to prevent overheating.
Input Currents (IIH, IIL):
- High-level input current should be around 1 microampere, and low-level input current should be around -1 microampere.
Output Currents (IOH, IOL):
- The device can sink up to 16 milliamperes and source up to -4 milliamperes at the output pins.
Additional Notes:
- Always refer to the datasheet for the most accurate and detailed information.
- Proper decoupling capacitors should be used near the power supply pins to filter out noise and ensure stable operation.
- Follow good PCB layout practices to minimize signal interference and improve performance.
Inquiry - IDT74FCT164245TPA
