Share:
Specifications
SKU: 11761211
| Parameter | Description | Value |
|---|---|---|
| Device Type | Programmable Array Logic with CMOS EEPROM Technology | PALCE22V10H-10PC/5 |
| Package Type | Plastic Dual In-Line Package (PDIP) | 20-Pin |
| Operating Voltage (VCC) | Supply Voltage Range | 4.5V to 5.5V |
| Maximum Power Consumption | Total Power Consumption at Maximum Operating Conditions | 100mW |
| Maximum Current per I/O | Maximum Current per Input/Output Pin | ±25mA |
| Maximum Current (VCC) | Maximum Current through VCC Pin | 100mA |
| Maximum Current (GND) | Maximum Current through GND Pin | 100mA |
| Input Voltage (VIH) | Minimum Input High Voltage | 2.0V |
| Input Voltage (VIL) | Maximum Input Low Voltage | 0.8V |
| Output Voltage (VOH) | Minimum Output High Voltage | 2.4V |
| Output Voltage (VOL) | Maximum Output Low Voltage | 0.4V |
| Propagation Delay Time | Typical Propagation Delay Time (tPLH, tPHL) | 12ns |
| Programming Voltage | Voltage Required for Programming | 12.5V |
| Erasing Time | Typical Erase Time | 10 seconds |
| Programming Time | Typical Programming Time | 1 second |
| Operating Temperature | Operating Temperature Range | -40°C to +85°C |
| Storage Temperature | Storage Temperature Range | -65°C to +150°C |
| Humidity | Relative Humidity Range | 0% to 95% (Non-condensing) |
| ESD Rating | Human Body Model (HBM) ESD Rating | 2000V |
| Mounting Type | Mounting Method | Through-Hole |
Instructions:
Power Supply:
- Connect VCC to a stable 5V power supply.
- Ensure the ground (GND) is properly connected.
Programming:
- Use a compatible programmer to program the device.
- Apply the programming voltage (12.5V) to the appropriate pin during programming.
- Follow the programming algorithm provided by the manufacturer.
Erasing:
- Use a UV eraser or an electrical erase method to erase the device.
- Ensure the device is exposed to the UV light for at least 10 seconds.
Handling:
- Handle the device with care to avoid static damage.
- Store in a dry environment to prevent moisture damage.
Mounting:
- Insert the device into the PCB holes carefully.
- Solder the pins securely, ensuring good thermal contact.
Testing:
- After mounting, test the device under typical operating conditions to ensure proper functionality.
- Check for any shorts or open circuits on the PCB.
Safety:
- Do not exceed the maximum ratings specified in the table.
- Use appropriate safety equipment when handling high voltages.
Inquiry - PALCE22V10H-10PC/5
