Instructions for Use:

1. Input Voltage (V_IN):

   • Ensure the input voltage is within the range of 8V to 30V.
   • The higher the input voltage, the more power dissipation will occur, which may require additional heat sinking.

2. Output Voltage (V_OUT):

   • The output voltage is fixed at 12V. No external components are required to set this voltage.

3. Output Current (I_OUT):

   • The device can provide up to 1.5A of output current, with a typical value of 1A.
   • For continuous operation at higher currents, ensure proper heat dissipation.

4. Quiescent Current (I_Q):

   • The quiescent current is typically 5mA and can go up to 10mA.
   • This is the current consumed by the regulator when no load is applied.

5. Dropout Voltage (V_DROP):

   • The dropout voltage is the minimum difference between the input and output voltages required for the regulator to maintain regulation.
   • It is typically 1.3V and can go up to 1.7V.

6. Line Regulation:

   • The line regulation is the change in output voltage due to changes in input voltage.
   • It is typically 0.01% and can go up to 0.05%.

7. Load Regulation:

   • The load regulation is the change in output voltage due to changes in load current.
   • It is typically 0.01% and can go up to 0.05%.

8. Thermal Shutdown (T_SD):

   • The device will shut down if the junction temperature exceeds 160°C to prevent damage.
   • Ensure adequate cooling to avoid thermal shutdown.

9. Operating Junction Temperature (T_J):

   • The operating junction temperature range is from -40°C to 125°C.
   • Ensure that the device operates within this range to avoid performance degradation or failure.

10. Storage Temperature (T_STORAGE):

    • The storage temperature range is from -65°C to 150°C.
    • Store the device in a dry environment within this temperature range to maintain reliability.

Additional Notes:

• Heat Sinking:
  • For high current applications, consider using a heat sink to improve thermal performance.
• Capacitors:
  • Use input and output capacitors as recommended in the datasheet to stabilize the regulator and filter noise.
• PCB Layout:
  • Follow good PCB layout practices to minimize noise and ensure stable operation.