Instructions for Use:

1. Power Supply:

   • Connect the +5 V power supply to pin 16 (VCC) and ground to pin 8 (GND).

2. Reference Voltage:

   • Apply the reference voltage to pin 1 (REF IN). The maximum reference voltage is 10 V.

3. Digital Input:

   • Connect the 12-bit parallel data input lines (D0 to D11) to the appropriate control logic or microcontroller.
   • D0 is the least significant bit (LSB), and D11 is the most significant bit (MSB).

4. Control Signals:

   • Chip Select (CS): Active low. Connect to the control logic to enable the device.
   • Write (WR): Active low. Used to latch the data into the DAC register.
   • Data Output Enable (OE): Active low. Used to enable the data output lines (if required).

5. Output Current:

   • The current output is available at pin 15 (IOUT). This can be connected to a load resistor to convert the current to a voltage if needed.

6. Temperature Considerations:

   • Ensure that the operating temperature range is between -40°C and +85°C to maintain performance specifications.

7. Handling Precautions:

   • Handle the device with care to avoid static discharge, which can damage the internal circuits.
   • Ensure proper grounding and shielding to minimize noise interference.

8. Testing:

   • After assembly, verify the correct operation by applying known digital codes and measuring the corresponding output current.

9. Storage:

   • Store the device in a dry, cool place to prevent moisture damage.

For detailed application notes and further information, refer to the datasheet provided by Analog Devices.