Below is the parameter table and instructions for the Skiip 26AC126V1:

Parameter Table

Instructions

1. Installation:

   • Ensure that the input voltage (3 to 32 VDC) and output voltage (80 to 280 VAC) are within the specified range.
   • Mount the relay on a suitable PCB or terminal block using through-hole mounting.
   • Use appropriate wire gauges for connections to handle the current ratings.

2. Wiring:

   • Connect the input control signal to the designated input terminals (typically labeled as "IN1" and "IN2").
   • Connect the load to the output terminals (typically labeled as "OUT1" and "OUT2").
   • Ensure all connections are secure and insulated to prevent short circuits.

3. Operation:

   • Apply the control voltage to the input terminals to switch the relay ON.
   • Remove the control voltage to switch the relay OFF.
   • The relay will switch the AC load based on the applied control signal.

4. Safety Precautions:

   • Handle the relay with care to avoid damage to the components.
   • Ensure the relay is properly isolated from high-voltage circuits to prevent electrical shock.
   • Do not exceed the maximum operating temperature to avoid thermal damage.
   • Use a heat sink if necessary, especially for high current applications.

5. Maintenance:

   • Regularly inspect the relay for signs of wear or damage.
   • Clean the relay and surrounding area to remove dust and debris.
   • Replace the relay if it shows signs of malfunction or failure.

By following these parameters and instructions, you can ensure reliable and safe operation of the Skiip 26AC126V1 AC solid state relay.