Below is the parameter table and instructions for the component 072-0043.

Parameter Table

Instructions

1. Handling and Storage:

   • Handle with care to avoid damage.
   • Store in a dry, cool place away from direct sunlight.
   • Avoid exposure to corrosive substances.

2. Soldering:

   • Use a temperature-controlled soldering iron set to 350°C (662°F) or less.
   • Solder each terminal for no more than 3 seconds.
   • Allow the component to cool naturally after soldering.

3. Mounting:

   • Ensure the board is clean and free of contaminants before mounting.
   • Place the component on the board with the correct orientation.
   • Apply light pressure to ensure good contact with the solder pads.

4. Inspection:

   • Visually inspect the solder joints to ensure they are smooth and free of voids.
   • Check for any signs of damage or misalignment.

5. Testing:

   • Use a multimeter to verify the resistance value.
   • Ensure the component meets the specified tolerance of ±1%.

6. Disposal:

   • Dispose of the component according to local environmental regulations.
   • Do not incinerate or dispose of in regular trash.

By following these instructions, you can ensure the proper handling, installation, and maintenance of the 072-0043 component.