Instructions for Using the N5532:

1. Supply Voltage:

   • Ensure the supply voltage is within the range of 4.5V to 16V.
   • Connect the positive terminal of the power supply to Vcc and the negative terminal to ground (GND).

2. Input Voltage:

   • The input voltage should be within the range of -0.3V to Vcc + 0.3V.
   • Connect the input signal to the IN pin.

3. Output Voltage:

   • The output voltage will be within the range of -0.3V to Vcc - 1.5V.
   • Connect the load or next stage to the OUT pin.

4. Quiescent Current:

   • The quiescent current is typically 0.5mA. This is the current consumed by the op-amp when no load is connected.

5. Output Current:

   • The typical output current is 10mA, with a maximum of 30mA. Ensure that the load does not exceed this limit to avoid damage.

6. Power Supply Rejection Ratio (PSRR):

   • The PSRR at 1kHz is 78dB, indicating good rejection of power supply noise.

7. Slew Rate:

   • The slew rate is 0.5V/μs, which limits the maximum rate of change of the output voltage.

8. Input Offset Voltage:

   • The input offset voltage is typically 2mV. This is the voltage difference between the two input terminals when the output is zero.

9. Input Bias Current:

   • The input bias current is typically 50nA. This is the average current flowing into the input terminals.

10. Common Mode Rejection Ratio (CMRR):

    • The CMRR is 80dB, indicating good rejection of common mode signals.

11. General Usage:

    • Use the N5532 in applications requiring low noise, high gain, and moderate speed.
    • Ensure proper decoupling capacitors are used to stabilize the power supply and reduce noise.
    • Refer to the datasheet for more detailed information and specific application circuits.