Instructions for Use:

1. Handling Precautions:

   • Handle the diodes with care to avoid mechanical damage.
   • Avoid touching the leads or body of the diode directly to prevent static discharge.

2. Soldering:

   • Preheat the PCB to 100°C to 150°C before soldering.
   • Soldering temperature should not exceed 260°C.
   • Soldering time should be kept within 10 seconds.
   • Allow the diode to cool naturally after soldering.

3. Mounting:

   • Ensure proper heat dissipation by using a heatsink if necessary.
   • Tighten the mounting screws to the recommended torque to ensure good thermal contact.

4. Electrical Connections:

   • Connect the cathode (marked with a band) to the positive side of the circuit.
   • Connect the anode to the negative side of the circuit.
   • Ensure that the maximum reverse voltage and forward current ratings are not exceeded.

5. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Keep in original packaging until ready to use to protect from moisture and static.

6. Testing:

   • Use a multimeter to test the diode for continuity and reverse bias.
   • In forward bias, the diode should conduct with a voltage drop close to the specified Vf.
   • In reverse bias, the diode should block current and show an open circuit.

7. Safety:

   • Always disconnect power before making any changes to the circuit.
   • Use appropriate safety equipment when handling high voltages.