Below is the parameter table and instructions for the GAL16V8D-15LJ:

GAL16V8D-15LJ Parameter Table

Instructions for GAL16V8D-15LJ

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the range of 4.5 V to 5.5 V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Input Signals:

   • Apply input signals such that the high level (VIH) is at least 2.0 V and the low level (VIL) is at most 0.8 V.
   • Avoid applying voltages outside the specified range to prevent damage to the device.

3. Output Signals:

   • When the output is high (VOH), it should be at least 2.4 V and can go up to 5.0 V.
   • When the output is low (VOL), it should be at most 0.5 V.
   • Ensure that the load current does not exceed 4.0 mA for reliable operation.

4. Propagation Delay:

   • The propagation delay time (tpd) is typically 15 ns under standard conditions (VCC = 5.0 V, TA = 25°C).
   • Consider this delay when designing your circuit to ensure proper timing.

5. Power Consumption:

   • The typical power consumption (ICC) is 10 mA when all outputs are low.
   • Monitor the power consumption to ensure it does not exceed the maximum rating.

6. Temperature Range:

   • Operate the device within the temperature range of -40°C to 85°C.
   • Store the device within the temperature range of -65°C to 150°C.

7. Programming:

   • Use a compatible programmer to program the GAL16V8D-15LJ with the desired logic function.
   • Follow the programming guidelines provided by the manufacturer to ensure correct configuration.

8. Handling:

   • Handle the device with care to avoid static discharge, which can damage the internal circuits.
   • Use proper ESD protection measures when handling the device.

By following these parameters and instructions, you can ensure reliable operation and longevity of the GAL16V8D-15LJ in your application.