Below is the parameter table and instructions for the JW2SN-DC24V.

Parameter Table

Instructions

1. Installation:

   • Ensure that the input voltage is DC 24V.
   • Mount the JW2SN-DC24V on a suitable panel using the provided mounting screws.
   • Connect the input wires to the terminal block labeled "IN" and the output wires to the terminal block labeled "OUT."

2. Wiring:

   • Input Wiring:
     • Connect the positive terminal of the power supply to the "+" terminal.
     • Connect the negative terminal of the power supply to the "-" terminal.
   • Output Wiring:
     • Connect the load to the "COM" and "NO" terminals.
     • The "COM" terminal is the common terminal.
     • The "NO" terminal is the normally open terminal.

3. Operation:

   • When the sensor detects the target, the relay will switch from the normally open (NO) state to the closed state, allowing current to flow through the load.
   • The response time is less than 10ms, ensuring quick and reliable operation.

4. Maintenance:

   • Regularly inspect the connections for any signs of wear or damage.
   • Ensure that the operating environment is within the specified temperature and humidity ranges.
   • Do not exceed the maximum current rating of 5A at 24V DC to avoid damage to the relay.

5. Troubleshooting:

   • No Output:
     • Check the input voltage and ensure it is DC 24V.
     • Verify that the connections are secure and not loose.
   • Intermittent Operation:
     • Check for any interference or noise in the power supply.
     • Ensure that the load is within the switching capacity of the relay.

6. Safety Precautions:

   • Always disconnect the power supply before installing or servicing the relay.
   • Use appropriate personal protective equipment (PPE) when handling electrical components.
   • Follow all local electrical codes and regulations.

By following these instructions, you can ensure the safe and efficient operation of the JW2SN-DC24V relay.