Share:
Specifications
SKU: 12598412
| Parameter | Description | Value |
|---|---|---|
| Part Number | Full part number | SRG-SH-112DM1 |
| Type | Type of component | DC-DC Converter |
| Input Voltage Range | Range of input voltage | 4.5V to 16V |
| Output Voltage | Fixed output voltage | 12V |
| Output Current | Maximum continuous output current | 1A |
| Efficiency | Typical efficiency at full load | 92% |
| Operating Temperature | Operating temperature range | -40°C to +85°C |
| Storage Temperature | Storage temperature range | -55°C to +125°C |
| Package Size | Dimensions (L x W x H) | 11.2mm x 7.0mm x 7.0mm |
| Pin Configuration | Pin arrangement | See pinout diagram below |
| Mounting Type | Mounting method | Surface Mount |
| Protection Features | Built-in protection | Overvoltage, Overcurrent, Thermal Shutdown |
Pinout Diagram
| Pin Number | Pin Name | Description |
|---|---|---|
| 1 | VIN | Input Voltage |
| 2 | GND | Ground |
| 3 | VOUT | Output Voltage |
| 4 | EN | Enable (High = ON, Low = OFF) |
| 5 | FB | Feedback for output voltage adjustment |
Instructions for Use
Power Supply Connection:
- Connect the input voltage to the VIN pin.
- Ensure the input voltage is within the specified range (4.5V to 16V).
- Connect the ground (GND) pin to the common ground of your system.
Output Connection:
- Connect the load to the VOUT pin.
- The output voltage is fixed at 12V.
Enable Control:
- To enable the converter, apply a high signal (typically above 2.0V) to the EN pin.
- To disable the converter, apply a low signal (typically below 0.8V) to the EN pin.
Feedback Adjustment:
- The FB pin can be used for output voltage adjustment if needed. Refer to the datasheet for specific resistor values to achieve the desired output voltage.
Thermal Management:
- Ensure adequate heat dissipation by providing sufficient PCB copper area or a heatsink if operating at high temperatures or under high load conditions.
Storage and Handling:
- Store the component in a dry environment within the specified storage temperature range (-55°C to +125°C).
- Handle with care to avoid damage to the pins and body.
Safety Precautions:
- Do not exceed the maximum input voltage to prevent damage to the converter.
- Ensure proper grounding to avoid electrical hazards.
- Follow all relevant safety guidelines when handling electronic components.
Inquiry - SRG-SH-112DM1
