Instructions for Using FAN7320

1. Supply Voltage (VCC):

   • Ensure the supply voltage is within the range of 4.5V to 20V.
   • Avoid exceeding 20V to prevent damage to the device.

2. Gate Drive Voltages:

   • The high-side gate drive voltage (VGH) should be set to the same as VCC or up to 15V.
   • The low-side gate drive voltage (VGL) should be set to 0V or up to 5V.

3. Gate Drive Currents:

   • The source and sink currents for the high and low sides should not exceed 3.5A.
   • Ensure the load resistance (RL) is appropriate to avoid excessive current draw.

4. Propagation Delays:

   • The propagation delay times (tDHL and tDLH) are critical for timing accuracy.
   • Ensure these delays are within the specified range to avoid timing issues.

5. Delay Skew:

   • The delay skew (tDSK) should be kept within ±20ns to maintain synchronization between high and low sides.

6. Minimum Pulse Width:

   • The minimum pulse width (tPWmin) should be at least 60ns to ensure proper switching.

7. Maximum Duty Cycle:

   • The maximum duty cycle (Dmax) should not exceed 99% to prevent continuous conduction.

8. Operating and Storage Temperatures:

   • The operating temperature range is from -40°C to 125°C.
   • The storage temperature range is from -40°C to 150°C.

9. Handling and Installation:

   • Handle the device with care to avoid static discharge.
   • Follow proper soldering techniques to ensure reliable connections.

10. Testing and Troubleshooting:

    • Use a multimeter to verify the supply voltage and gate drive voltages.
    • Check for any short circuits or open circuits in the circuit.
    • Refer to the datasheet for more detailed troubleshooting steps.