Below is the parameter table and instructions for the A6063H component.

Parameter Table

Instructions

1. Supply Voltage:

   • Ensure the supply voltage (Vcc) is within the range of 4.5V to 5.5V.
   • The typical operating voltage is 5.0V.

2. Output Current:

   • The output current when high (Ioh) can be up to 40mA.
   • The output current when low (Iol) can be up to 40mA.
   • Ensure the load resistance (RL) is appropriate to avoid exceeding these limits.

3. Input Voltage:

   • The input voltage for a high level (VIH) should be between 3.0V and 5.0V.
   • The input voltage for a low level (VIL) should be between 0.0V and 1.5V.

4. Propagation Delay:

   • The propagation delay time from high to low (tPLH) and from low to high (tPHL) is typically 15ns.
   • These values are measured with Vcc = 5V and a load resistance of 150Ω.

5. Power Consumption:

   • The power consumption (Pd) is typically 100mW at Vcc = 5V.

6. Operating Temperature:

   • The operating temperature range (Ta) is from -40°C to 85°C.
   • Ensure the component is used within this range to avoid damage.

7. Storage Temperature:

   • The storage temperature range (Tstg) is from -65°C to 150°C.
   • Store the component in a dry and cool place to prevent damage.

8. Handling:

   • Handle the component with care to avoid static discharge.
   • Use appropriate ESD protection when handling the component.

9. Mounting:

   • Follow the recommended soldering profile to ensure proper mounting.
   • Avoid excessive heat during soldering to prevent damage to the component.

10. Testing:

    • Test the component under controlled conditions to verify its performance.
    • Use a multimeter or an oscilloscope to measure the parameters as needed.

By following these instructions, you can ensure the A6063H operates reliably and efficiently in your application.