Share:
Specifications
SKU: 12611383
| Parameter | Symbol | Conditions | Min | Typical | Max | Unit |
|---|---|---|---|---|---|---|
| Supply Voltage | VCC | Operating | 4.5 | - | 5.5 | V |
| Standby Current | ICC(STBY) | VCC = 5V, All Outputs High | - | 50 | 100 | μA |
| Active Current | ICC(ACTIVE) | VCC = 5V, All Outputs High | - | 20 | 40 | mA |
| Output High Voltage | VOH | IO = -1mA, VCC = 5V | 2.4 | - | 5.0 | V |
| Output Low Voltage | VOL | IO = 16mA, VCC = 5V | 0 | - | 0.5 | V |
| Access Time | tAA | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 70 | - | - | ns |
| Address Setup Time | tAS | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 25 | - | - | ns |
| Address Hold Time | tAH | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 0 | - | - | ns |
| Output Enable Setup Time | tOE | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 25 | - | - | ns |
| Output Enable Hold Time | tOH | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 0 | - | - | ns |
| Chip Enable Setup Time | tCS | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 25 | - | - | ns |
| Chip Enable Hold Time | tCH | VCC = 5V, VIL = 0.8V, VIH = 2.0V | 0 | - | - | ns |
Instructions for Using M27C256B12F1
Power Supply:
- Connect the VCC pin to a 4.5V to 5.5V power supply.
- Connect the GND pin to ground.
Addressing:
- Apply the desired address to the address lines (A0-A17) to select the memory location.
- Ensure that the address setup time (tAS) is met before the rising edge of the chip enable (CE) signal.
Chip Enable (CE):
- Set CE low to enable the device for read operations.
- The chip enable hold time (tCH) must be maintained after the address is stable.
Output Enable (OE):
- Set OE low to enable the output drivers and allow data to be read from the selected memory location.
- The output enable setup time (tOE) must be met before the rising edge of the chip enable (CE) signal.
Data Output:
- Data will be available on the data output lines (D0-D7) after the access time (tAA).
- Ensure that the output enable hold time (tOH) is maintained to keep the data valid.
Standby Mode:
- To enter standby mode, set both CE and OE high. This will minimize power consumption.
Timing Considerations:
- Ensure all timing parameters (setup and hold times) are met to avoid data corruption or incorrect operation.
- Use appropriate pull-up resistors on the output lines if driving high-impedance loads.
Storage and Handling:
- Store the device in a dry, static-free environment.
- Handle with care to avoid damage to the pins and internal components.
By following these instructions, you can ensure reliable and efficient operation of the M27C256B12F1 EEPROM.
(For reference only)Inquiry - M27C256B12F1
