Instructions:

1. Installation:

   • Ensure the relay is installed in a well-ventilated area to prevent overheating.
   • Use appropriate wiring and connectors to connect the relay to your circuit.

2. Power Supply:

   • Connect the coil terminals to a 6V DC power supply.
   • Ensure the power supply can provide at least 90mA of current to operate the relay.

3. Control Signals:

   • Apply 6V DC to the coil to energize the relay and switch the contacts.
   • Remove the voltage to de-energize the relay and return the contacts to their default position.

4. Load Connection:

   • Connect the load to the common (COM) and normally open (NO) or normally closed (NC) terminals as required.
   • Ensure the load does not exceed the contact rating of 10A at 250VAC.

5. Testing:

   • Test the relay by applying and removing the control voltage to verify proper operation.
   • Check for continuity between the COM and NO/NC terminals when the relay is energized and de-energized.

6. Maintenance:

   • Regularly inspect the relay for signs of wear or damage.
   • Replace the relay if it fails to operate correctly or if any components are damaged.

7. Safety:

   • Do not exceed the rated voltage and current limits.
   • Avoid operating the relay in environments with excessive dust, moisture, or corrosive gases.
   • Ensure the relay is properly grounded to prevent electrical hazards.