Instructions for Use:

1. Input Voltage Range: Ensure the input voltage is within the range of 1.6V to 15V. The device will not function properly outside this range.
2. Output Voltage: The output voltage is fixed at 12V. No external components are required to set this voltage.
3. Output Current: The maximum continuous output current is 100mA. Exceeding this value can cause overheating and potential damage.
4. Line Regulation: The change in output voltage due to variations in input voltage is very low, typically 0.01% per volt.
5. Load Regulation: The change in output voltage due to variations in load current is also very low, typically 0.1% per milliamp.
6. Dropout Voltage: The minimum difference between the input and output voltages required for proper regulation is approximately 1.5V.
7. Quiescent Current: The device consumes approximately 5mA of current under no-load conditions.
8. Operating Temperature: The device is designed to operate within the temperature range of -40°C to 85°C. Operation outside this range may affect performance and reliability.
9. Storage Temperature: The device can be stored in temperatures ranging from -65°C to 150°C without damage.
10. Thermal Management: The thermal resistance from junction to ambient (θJA) is 150°C/W. Ensure adequate heat dissipation to prevent overheating, especially under high load conditions.

Schematic Example:

+Vin (1.6V to 15V)
  |
  |--- [MC78L12ACPG]
  |
+Vout (12V)
  |
  |--- Load (up to 100mA)

Pin Configuration:

• Pin 1 (Input): Connect to the input voltage source.
• Pin 2 (Ground): Connect to the ground.
• Pin 3 (Output): Connect to the load or output circuit.

Additional Notes:

• Always use appropriate decoupling capacitors (typically 0.1μF and 10μF) close to the input and output pins to ensure stable operation and filter out noise.
• For extended operation at high temperatures, consider using a heatsink or providing additional cooling.